Profile: Diameters from 2 to 20 mm

Optibelt RR round section belts are made from high quality polyurethane using a special manufacturing process. They are produced as open-ended belts in various diameters and are available by the metre.

The optibelt RR Plus version incorporates a polyester tension cord. The round section belts with tension cords are particularly low-stretch are therefore especially useful where longer transport distances need to be covered.



Profile: 8, Z/10, A/13, B/17, C/22



Profile: Y/6, 8, Z/10, A/13, B/17, 20, C/22, 25, D/32, E/40

Optimat V-belts are open-ended and are connected in an endless manner using a flexible connector once the belt length has been determined.

Optimat V-belts can be adjusted to corresponding lengths for all centre distances without any problems whatsoever. The belts can be supplied in any required length completely depending on the requirements of the drive.

Storage is simple and economical. With Optimat belts, it is not necessary to store different belt lengths for all possible uses in the warehouse. Optimat belts can be cut to the correct length according to the required drive on location.

Open-ended belting can be applied even when dealing with fixed centre distances. In the event of the belt stretching, the belt can be shortened in a few minutes. Optimat belts enable a quick installation, especially when using drives with a limited amount of access or drives with limited available space. The drive does not have to be dismantled when the belts have to be removed.